|
|
| Line 5: |
Line 5: |
|
| |
|
| == Dimmers == | | == Dimmers == |
| Strand 6pack Dimmer
| | See [[Dimmers|Dimmers]] |
| *DMX512 control via 5pin XLR. Pass Through
| |
| *6 10A channels, each with dual 15A sockets
| |
| *32A Power Cable
| |
| | |
| | |
| Eurolite DPX-405: (1 of)
| |
| * DMX512 control Via 3pin XLR. Pass Through.
| |
| * 4 5amp channels each.
| |
| * IEC sockets out.
| |
| * No Preheat.
| |
| * 13a Plug currently.
| |
| | |
| | |
| Double clunky 13a: (1 of)
| |
| * 2 13a channels each (MAX 2.5Kw each)
| |
| * 13a in and out for each channel
| |
| * Sliders / pots for control
| |
| * Max & min adjust (you'll need a flat screwdriver)
| |
| * Very useful on OB's. Don't hesitate to bring it!
| |
|
| |
|
| == Desk == | | == Desk == |
| Line 189: |
Line 170: |
| ==Old/unused Equipment== | | ==Old/unused Equipment== |
| This is equipment that is still owned by YSTV and is stored within the studio, but is not currently in use due to newer equipment/incompatibility with current equipment in use. | | This is equipment that is still owned by YSTV and is stored within the studio, but is not currently in use due to newer equipment/incompatibility with current equipment in use. |
|
| |
| Pulsar status dimmers: (2 of)
| |
| * 8-pin Din analogue signal in, 0-10v
| |
| * With pre-heat (good for not shocking cold bulbs if they suddenly get turned on, this increases lamp life.
| |
| * 6 5amp channels each.
| |
| * IEC plugs on flying leads out.
| |
| * If they're buzzing, they're happy!
| |
| **'''faults'''
| |
| ***Top dimmer channel 3, Likes to turn itself on to around 30% after a while. i.e. It's level can be raised, but not lowered beyond 30%. The time taken for this fault to appear can be minutes, or hours. It does not seem to be linked to heat - on 18/02/2010 the behaviour was observed when warm, and cold (given a break for 1/2 hour before retrying). This dimmer channel corresponds on the desk to what was "old channel I" - i.e. pre 18/02/2010 it would have been bottom dimmer channel 3..
| |
| ***Bottom dimmer channel 3, The transistor/triac looks fried and has continuity between the emitter and collector, also two medium-power 270 Ohm resistors have physically split. This dimmer channel corresponds on the desk to what was "old channel C" - i.e. pre 18/02/2010 it would have been top dimmer channel 3..
| |
| ***One dimmer is without a power cable - this was due to power cable being needed for the Strand 6pack
| |
|
| |
|
|
| |
|
| Zero88 Sirius24 (2 of) | | [[Zero88 Sirius 24|Zero88 Sirius 24]] |
|
| |
|
| [[Category:Technical]] | | [[Category:Technical]] |
| [[Category:Lighting]] | | [[Category:Lighting]] |
