G/046 Lighting Rig: Difference between revisions

G/046 Lighting Rig (view source)

Revision as of 10:41, 16 August 2013

1,661 bytes removed , 16 August 2013

m

moved dimmers to seperate page and added links

camera trained, confluence-users, coshh trained, crowd-administrators, domain admins, domain users, jira-administrators, jira-developers, jira-users, ladder trained, lighting trained, stash-users, webdev

392

edits

@@ Line 5: / Line 5: @@
 == Dimmers ==
-Strand 6pack Dimmer
+See [[Dimmers|Dimmers]]
-*DMX512 control via 5pin XLR. Pass Through
-*6 10A channels, each with dual 15A sockets
-*32A Power Cable
-Eurolite DPX-405: (1 of)
-* DMX512 control Via 3pin XLR. Pass Through.
-* 4 5amp channels each.
-* IEC sockets out.
-* No Preheat.
-* 13a Plug currently.
-Double clunky 13a: (1 of)
-* 2 13a channels each (MAX 2.5Kw each)
-* 13a in and out for each channel
-* Sliders / pots for control
-* Max & min adjust (you'll need a flat screwdriver)
-* Very useful on OB's. Don't hesitate to bring it!
 == Desk ==
@@ Line 189: / Line 170: @@
 ==Old/unused Equipment==
 This is equipment that is still owned by YSTV and is stored within the studio, but is not currently in use due to newer equipment/incompatibility with current equipment in use.
-Pulsar status dimmers: (2 of)
-* 8-pin Din analogue signal in, 0-10v
-* With pre-heat (good for not shocking cold bulbs if they suddenly get turned on, this increases lamp life.
-* 6 5amp channels each.
-* IEC plugs on flying leads out.
-* If they're buzzing, they're happy!
-**'''faults'''
-***Top dimmer channel 3, Likes to turn itself on to around 30% after a while. i.e. It's level can be raised, but not lowered beyond 30%. The time taken for this fault to appear can be minutes, or hours. It does not seem to be linked to heat - on 18/02/2010 the behaviour was observed when warm, and cold (given a break for 1/2 hour before retrying). This dimmer channel corresponds on the desk to what was "old channel I" - i.e. pre 18/02/2010 it would have been bottom dimmer channel 3..
-***Bottom dimmer channel 3, The transistor/triac looks fried and has continuity between the emitter and collector, also two medium-power 270 Ohm resistors have physically split. This dimmer channel corresponds on the desk to what was "old channel C" - i.e. pre 18/02/2010 it would have been top dimmer channel 3..
-***One dimmer is without a power cable - this was due to power cable being needed for the Strand 6pack
-Zero88 Sirius24 (2 of)
+[[Zero88 Sirius 24|Zero88 Sirius 24]]
 [[Category:Technical]]
 [[Category:Lighting]]