Sony HVR-HD1000E
 HD OK
|
These are the main HD camera's currently used in YSTV. There were at one time four of these, only two of these now function but none record to tape.
They record at 1440x1080i50 (anamorphic) onto HDV tape for capture, and do live video out over HDMI or Composite. They have a good set of functions, setup by a touch screen and controlled during use by buttons and a fly-by-wire ring. We currently use them in preference to all our other cameras for pretty much everything.
The original three cameras - and the associated tripod, lamp, wired remote control, and bag - were donated with money from the Alumni Fund.
Power
These camera's are picky in that they need 8.7V through a propriety connector. There is an adapter cable-tied to each camera to allow the use of 4-pin XLR to provide power. However, care must be taken to avoid plugging a 12V supply into the camera's. Doing this turns the camera into a 'tape muncher', among other problems.
Current condition
Due to the use of incompatible power supplies (see above), two of YSTV's three HVRs are currently 'tape munchers'. A somewhat extremely unreliable solid-state recorder can be used with these cameras.
The other camera records to tape fine. It used to have issues with sound due to a damaged microphone jack, but that has been fixed using spare parts from an older non-functioning HVR (again due to incorrect power supply). This camera also suffers from occasional optical issues, producing a distorted image.
The former working HVR ceased functioning for reasons unknown on 25/11/13, leaving YSTV with no method to record from a HVR.
Both cameras can be used for live shows, both in HD and SD. During their use at Woodstock 2009 the video out and umbilical were dangling directly from the composite socket for some of the show. The weight of the umbilical and the movement of the camera damaged the composite sockets of two of the cameras. These were re-soldered to the circuit board in the Easter vacation of 2010, but have since been damaged again. In an SD setup, the S-Video connection should be used instead. The exception to this is the one 'non-tape-muncher', that has a BNC mounted to it.
HD requires the use of battery converters to work with BNC cabling.
Repair notes
Composite socket
In order to resolder the composite socket it is necessary to take off the side of the camera which has the speaker in - i.e. the side which rests against your face in shoulder-mounted operation. This requires removing four large screws on the large panel, the shoulder rest, two screws under the shoulder rest, one screw near the front of the camera on its base, one small one slightly on the right-hand side of the top of the lens, and one small one on the left hand side underneath the lens.
